Lisa pixel size ajustment
Posted: February 22nd, 1985, 4:10 am
Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.2 9/18/84; site uw-beaver
Path: utzoo!watmath!clyde!cbosgd!ulysses!mhuxr!mhuxb!mhuxn!mhuxm!mhuxj!houxm!vax135!cornell!uw-beaver!info-mac
From: info-mac@uw-beaver
Newsgroups: fa.info-mac
Subject: Lisa pixel size ajustment
Message-ID:
Date: Tue, 5-Feb-85 02:39:19 EST
Article-I.D.: uw-beave.753
Posted: Tue Feb 5 02:39:19 1985
Date-Received: Thu, 7-Feb-85 03:26:45 EST
Sender: daemon@uw-beaver
Organization: U of Washington Computer Science
Lines: 18
From: [email protected]
From CompuServe MAUG:
Fm: Dennis Brothers
The height adjustment is near the top, just left center, about two-thirds of
the way back. You need to remove the top panel - remove the card cage from the
rear, and there are two screws that fasten down the rear of the top which are
now accessible (may not be necessary to remove the card cage, but I had it out
when I removed those screws). Be aware that there will be a three-way
interaction between height, vertical linearity, and vertical position.
[email protected]
PS: Remember that your Lisa stuff will look squished. I haven't tried this
yet. I may not since I use my Mac for Paint stuff and Lisa for Write and
Mac development.
Posting-Version: version B 2.10.2 9/18/84; site uw-beaver
Path: utzoo!watmath!clyde!cbosgd!ulysses!mhuxr!mhuxb!mhuxn!mhuxm!mhuxj!houxm!vax135!cornell!uw-beaver!info-mac
From: info-mac@uw-beaver
Newsgroups: fa.info-mac
Subject: Lisa pixel size ajustment
Message-ID:
Date: Tue, 5-Feb-85 02:39:19 EST
Article-I.D.: uw-beave.753
Posted: Tue Feb 5 02:39:19 1985
Date-Received: Thu, 7-Feb-85 03:26:45 EST
Sender: daemon@uw-beaver
Organization: U of Washington Computer Science
Lines: 18
From: [email protected]
From CompuServe MAUG:
Fm: Dennis Brothers
The height adjustment is near the top, just left center, about two-thirds of
the way back. You need to remove the top panel - remove the card cage from the
rear, and there are two screws that fasten down the rear of the top which are
now accessible (may not be necessary to remove the card cage, but I had it out
when I removed those screws). Be aware that there will be a three-way
interaction between height, vertical linearity, and vertical position.
[email protected]
PS: Remember that your Lisa stuff will look squished. I haven't tried this
yet. I may not since I use my Mac for Paint stuff and Lisa for Write and
Mac development.