Macput/MacTerm
Posted: November 21st, 1984, 11:09 pm
Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10 UW 5/3/83; site uw-beaver
Path: utzoo!watmath!clyde!burl!ulysses!mhuxj!houxm!hogpc!houti!ariel!vax135!cornell!uw-beaver!info-mac
From: [email protected]
Newsgroups: fa.info-mac
Subject: Macput/MacTerm
Message-ID:
Date: Sat, 13-Oct-84 20:09:32 EDT
Article-I.D.: uw-beave.1915
Posted: Sat Oct 13 20:09:32 1984
Date-Received: Tue, 16-Oct-84 05:02:12 EDT
Sender: daemon@uw-beave
Organization: U of Washington Computer Science
Lines: 7
From: Barry Eynon
Despite the claims in the man file, I still seem to find that it is
necessary to disable the XON/XOFF flow control when using macput over a
1200 baud phone line (MacTerm 1.1, Vax 4.2, direct phone port). Otherwise
I get some "Bad FileInfo block..." message. Anyone else notice this?
-Barry Eynon
-------
Posting-Version: version B 2.10 UW 5/3/83; site uw-beaver
Path: utzoo!watmath!clyde!burl!ulysses!mhuxj!houxm!hogpc!houti!ariel!vax135!cornell!uw-beaver!info-mac
From: [email protected]
Newsgroups: fa.info-mac
Subject: Macput/MacTerm
Message-ID:
Date: Sat, 13-Oct-84 20:09:32 EDT
Article-I.D.: uw-beave.1915
Posted: Sat Oct 13 20:09:32 1984
Date-Received: Tue, 16-Oct-84 05:02:12 EDT
Sender: daemon@uw-beave
Organization: U of Washington Computer Science
Lines: 7
From: Barry Eynon
Despite the claims in the man file, I still seem to find that it is
necessary to disable the XON/XOFF flow control when using macput over a
1200 baud phone line (MacTerm 1.1, Vax 4.2, direct phone port). Otherwise
I get some "Bad FileInfo block..." message. Anyone else notice this?
-Barry Eynon
-------