Macput Questions
Posted: September 23rd, 1984, 4:53 am
Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10 UW 5/3/83; site uw-beaver
Path: utzoo!watmath!clyde!burl!ulysses!mhuxl!houxm!houxz!vax135!cornell!uw-beaver!info-mac
From: info-mac@uw-beaver (info-mac)
Newsgroups: fa.info-mac
Subject: Macput Questions
Message-ID:
Date: Tue, 21-Aug-84 20:23:30 EDT
Article-I.D.: uw-beaver>.1531
Posted: Tue Aug 21 20:23:30 1984
Date-Received: Thu, 23-Aug-84 00:11:59 EDT
Sender: daemon@uw-beave
Organization: U of Washington Computer Science
Lines: 25
From: John Mitchener PO
I am trying to use macput with System V and am having some problems. I
am not sure whether the problem lies with using System V, going through
a TAC, using MacTerminal -0.15, or plain ignorance. Any help would be
appreciated.
Macput.c compiles without error. Using fromhex results in a "Good
Checksum" message on a .dl file from the info-mac archives. The
resulting file is named calendar.rsrc. The connection is established
through the TAC and the following command is issued:
macput -o -r calendar
MacTerminal has been set to have no flow control and to show the
connection at the other end to be another Mac. After a short burst of
data over the modem, the Mac disk spins and the following appears in an
alert box:
Got IO Error 1 Got BadResult -
getBlock from getInfo
Any ideas?
John Mitchener
[email protected]
Posting-Version: version B 2.10 UW 5/3/83; site uw-beaver
Path: utzoo!watmath!clyde!burl!ulysses!mhuxl!houxm!houxz!vax135!cornell!uw-beaver!info-mac
From: info-mac@uw-beaver (info-mac)
Newsgroups: fa.info-mac
Subject: Macput Questions
Message-ID:
Date: Tue, 21-Aug-84 20:23:30 EDT
Article-I.D.: uw-beaver>.1531
Posted: Tue Aug 21 20:23:30 1984
Date-Received: Thu, 23-Aug-84 00:11:59 EDT
Sender: daemon@uw-beave
Organization: U of Washington Computer Science
Lines: 25
From: John Mitchener PO
I am trying to use macput with System V and am having some problems. I
am not sure whether the problem lies with using System V, going through
a TAC, using MacTerminal -0.15, or plain ignorance. Any help would be
appreciated.
Macput.c compiles without error. Using fromhex results in a "Good
Checksum" message on a .dl file from the info-mac archives. The
resulting file is named calendar.rsrc. The connection is established
through the TAC and the following command is issued:
macput -o -r calendar
MacTerminal has been set to have no flow control and to show the
connection at the other end to be another Mac. After a short burst of
data over the modem, the Mac disk spins and the following appears in an
alert box:
Got IO Error 1 Got BadResult -
getBlock from getInfo
Any ideas?
John Mitchener
[email protected]